Recent content by Michigandad3

Fantastic videos! Thank you very much! I ordered the MK Kit today. I have a bigger problems with lizards and frogs, so this screen is perfect.

Great idea. I also found toads, frogs and lizards in my heater.

I read somewhere on this site that the Sta-Rite heater is a favorite of rats. My problem is that lizards and frogs are drawn to the heat, and that food source attracts other critters. What can I do? Put window screen around all vents?

After taking the heater apart enough to see everything, rats have totally destroyed my heater. I purchased a nickel cupro raypak . Will rats attack this unit?

I also get cloudy water when borax is added after an ascorbic acid treatment to get rid of iron stains. This has happened twice. Lowered the ph to 7 Added ascorbic acid Stains gone Added sequestering agent Slowly raised Chlorine to 2 Added borax to raise ph to 7.2 (cloudy) Wait a couple days...

If I have to replace the heater, I am considering going with a commercial heater. I live in Houston, and we heat the pool year round. I am considering these two heaters" Raypak Digital ASME low NOx, commercial ASME heater 400,000 btu, Natural gas Hayward H400FDNASME Natural Gas Commercial...

Hello, The heating rate slows, then a Service Heater" error code appears on the from of the board, there are no LEDs lighting up on the rear of the board. I will check the Fenwal Ignition Control Module. Additional information I opened the heater approximately one year ago, and found two frog...

The heater is 400,000 BTU/hour, and is approximately 3 years old. The display shows 'Service Heater". There are no LEDs illuminated on the back of the board. I may be mistaken about the heat rate, but I can turn the heater on in the morning when the temperature is 70 degrees, and by evening it...

My Max-E-Them heater runs for a few hours then the service heater light comes on. If I turn off the heater and wait a couple hours, the heater will come back on. Also, the effectiveness of the heater decreases the longer it is on. For example, the temperature in the pool raises from 70 to 80...

What is the disadvantage of using the tabs, and draining water and adding fresh water to keep the CYA inline?

Thanks for all the advise! I adjusted the calcium, and dropped the pH to 7.2, and this past day the pH did not move! Lets hope the number of pebbles falling off reduces.

When I drained my water a few days ago to lower the CYS I switched from tabs to liquid chlorine. Yesterday evening I added muratic acid, and the pH was 7.4. This morning, the pH is 7.4-7.5. Your comment on the plaster scares me. When I run my vacuum, I also get a handful of blue pebbles from my...

I am testing approximately 2 hours after adding the muratic acid and liquid chlorine, and levels are correct. I test again 22 hours later, and FC is low and pH is high. This is the same plaster (pebblesheen) from 10 years ago. Thanks for all the advice.

I am using approximately 64 ounces of 10% liquid chlorine and 64 ounces of 31.45% muratic acid per day. - - - Updated - - - So I should use muratic acid every day to lower pH to a 7.0, and eventually it will stabilize? - - - Updated - - - I forgot to mention that I am in Houston, with...

I am using a TF-100 kit, and I have a small waterfall. The pool is approximately 10 years old, but I drained it 5 days ago to lower the CYA. After draining, I used ascorbic acid to eliminate iron stains, then I brushed thoroughly, and added a bottle of metal free.