Recent content by mfhearn

Fair enough.. links to pix.... used a fuji under water camera http://tinyurl.com/kz7qmbg http://tinyurl.com/lkmjd6j will try the magnet trick.....

Hi all. Gunite freeform pool built in 07. Has a cleaner system called PCC2000. Over time one of the water jets seemed to have worn away some of the plaster where there seems to be a black dot showing through. I called the builder (MDPOOLS) and sent many emails since 31 Aug 13 where a rep...

I have sent 5 separate notes to BIOGUARD regarding the wiring of the MS10 controller.... Not one response to any of the notes.... SO what i intend to do is hard wire the black wire to one of the Load poles and then the white wire to the neutral Buss and Ground to the Ground Buss.. The lack of...

I had the same problem a couple years ago.. I bought 2 of them... installed one.. fixed it... Now I just gotta remember where I put the other one... Good luck.

Jason, Thanks. Electricity around a pool is always worrisome. The MS10 panel is tied to a GFCI Outlet tied to its own 15A spst breaker. I think the rational there is that the AC plug as it is must be plugged into a GFCI outlet.. If it was hard wired in then the risk of plugging unplugging...

Yep Jason.. that is my conundrum.. manual has one reflection of wiring with terminals etc and the box has no jumpers or the like... cannot tell if it is autosensing.. no label reflecting that. no jumpers to use (and since it would be ac voltage I dont think any little jumpers are rated for the...

Hi Rambler, Thanks for the feedback. I had seen that and that was exactly what I was going to do.. until I opened the MS10 controller front panel and saw that there are no other terminals.. Picture of said connectors is in the link I posted in my initial post. I simply dont know if this is an...

Hi All, I am looking to wire a 220v pentair pool pump to a Intermatic ET8000 timer. In the directions there are a number of options and I am looking to wire the ET8215 DPST Option set for SImultaneous throw. But as this is a SW Pool I also have a Mineral Springs MS10 controller. After...

The idea of paying too much for the mineral springs is one that resonates with me too. And I too have been "poolstored" (which in and of itself is a term new to me.. ) So here is the question of alternative medicine for the pool comes up thus-Ly: Is there a recipe equivalent for the 30ish...