Recent content by mbreyer

Yep roll out get your pool on then. He wants your money. And as you know aluminum is metal LOL Sent from my SM-N910T using Tapatalk

Then ur good. City inspector would have nailed you if it wasnt up to code Sent from my SM-N910T using Tapatalk

I assumed ur part about aluminum post meant aluminum ground rod not aluminum sidewall or side rail. I read through that fast. Anyway im now harpin on how urs is done im nore trying to tell you how many different ways its done so expect many answers Sent from my SM-N910T using Tapatalk

And on top of the bonding ring you would need someway of then bonding this all to your water. Mine is via a return valve that has a coil that sits inside the return pipe Sent from my SM-N910T using Tapatalk

Its all about the path of least resistance. Copper as required and the steel on your pool wall provide a way less resistant path to ground than aluminum.(not as big a deal as if it were bonded to the resin siderails) Somebody somewhere did some math and found that ur way vs the ring had just a...

So you had the pool inspected like that after you or a contractor built it? City codes will vary but my particular city sided with your deck installer on the bonding ring Sent from my SM-N910T using Tapatalk

Pool level ok. No gasping from the skimmer Sent from my SM-N910T using Tapatalk

Sounds like you have a leak and our sucking air somewhere Sent from my SM-N910T using Tapatalk

Level with patience. Also take into account the way your liner attaches to the pool wall. You liner can stretch and you can have if off level but pool within reason. Take the level to your side rails dont eyeball the waterline. When i put my 24fter in i felt i was off as well despite using a...

Im going with u need to adjust the bottom rails to fit within the siderail foot print. They dont need to meet as mentioned. However when you put in the pool wall u may need to maneuver a bit to align all side post with ur blocks. Possibly even add a block somewhere. Sent from my SM-N910T using...