Thanks do much for the help. Will pick up cover tomorrow and start working on a solar heater for the side of my pool..
Sent from my SM-S920L using Tapatalk
So could you send a picture,it would be helpful also you mentioned you send water through the panels, do you have two covers on your pool?do you have a problem with algae on the covers,
Sent from my SM-S920L using Tapatalk
Salar panels could be install on the shed. The pool is too far from the house for national gas.
Have you used the solar cover does it work?
Sent from my SM-T530NU using Tapatalk
It is great when people are willing to help others, who are starting to understand the running of a swimming pool.
Sent from my SM-T530NU using Tapatalk
15x24 above oval pool vinyl.
Location mass
Cyanuric acid is 90
Calcium hardness 80
Fas/dpd 44
Cc 1
Total alkalinity ta 140
PH 7.5
Tccannot read off the charts.
Pool is now clear, but noticed some algae on the bottom corner.
What do I do next.?
Sent from my SM-T530NU using Tapatalk
I have read the slam instructions and this one part is unclear, I will do a partial drain and refill, would 1/5 change ok.
Sent from my SM-T530NU using Tapatalk
Just arrived my pool test kit tf-100
Numbers
Cyanuric acid 80
Calcium hardness 90
Fas/did chore test 14
Cc 1
Total alkalinity 150
PH 7.2
Tc cannot read over the chart level
Water is still light blue, 1/2 bleach each night pump running each day for 7 hours
Location worcester, ma
15×24 oval above...
Will add each night. Continue running the pump 24/7
A simple question is the water safe to swim in. I know the chlorine is high.
Sent from my SM-S920L using Tapatalk
15 x 24 oval above ground. 8496 gallons of water. Location worcester, ma. sand filter, vinyl pool
Have ordered my test kit should have it by the weekend...
Check my numbers today
Pool still cloudy light blue.
Fc. Ovr. 15.54 ppm
Tc. ovr. 15.54 ppm
Cc. 0.ppm
Ph. 7.8
Hardness. 31 ppm...