Recent content by Kimmisue

We replaced our T-5 with T-5 and it worked great for a week but today it says inspect cell and that light is blinking. :( My husband is ready to go buy truckloads of dirt to just fill the pool in!! No! help!

just ordered a T-5....returning the T-15....crossing my fingers

yep 1.40....

I think the guy who works on my pool is smoking crack.....and we just need to buy a T-5 and not a T-15.....

I'm not sure which software version it is....how do I find that out? (We did not install this.....it was here when we bought the home).

and it clearly says T-5 on the board....but we were told they no longer make T-5 and we need T-15....

I never get a "t" reading of any sort no matter how many times I push the diagnositic button and no matter which setting it is on. :hammer:

We were told we didn't need to change any settings....and I don't know where or how to do that...

I keep getting Hi salt readings on my SWG so it's not producing any chlorine. We've drained almost 1/3 or the pool, refilled and tried still no luck. SWG says salt is 4200. Strips and pool store say around 3200. I tried the steps to recalibrate but after I push the diagnostic button 5 times and...

i'm having this same problem but I drained almost 1/3 of my water and refilled and still says HI on SWG. Strips said 2800 and pool store (gasp) says 3300...not generating....brand new cell.....turned off the power to reset it and still have the same issue. any suggestions?

I can't find my chart that tells how much water and how much solution to mix to test my water....can't find one online....anyone know where I can look?

Well we were planning to submerge it in acid so depending on the size of the container we find to soak the cell in, it would probably be more than we usually put in to lower the pH and if it's cleaning stuff off of the cell, not sure I want dirty acid poured in my pool, do I?

We are going to soak our SWG cell in muriatic acid to clean it (and hope it fixes it). But once it's done soaking, how do we dispose of the acid? Also, Hubby wants to soad it over night, will that be too long?

Re: Blue Haven Smartpure Sanitizer inspect cell/low salt lig My husband said they did test the cell and it was working.....so......maybe not the cell? What else can I check?

We run our pump 24/7 and have our SWG turned up to 70-80% and now inspect cell and low salt lights are on. We've added a lot of salt, more than usual and it still says low salt. I'm guessing it's gone bad. This is our 3rd season in this house, so I'm guessing it's reached it's max life, not sure...