Recent content by KennyFlaming

That is what I did when I began to get the "cold" error a few months ago. It worked then and seems to work for this issue as well. Sent from my iPhone using Tapatalk

I did take the cover off an removed the display board. Shot some compressed air and tried to make sure everything was connected well. Put it back together and while it's only been a few hours it seems to work at this point. Sent from my iPhone using Tapatalk

Not sure how to add one, but I have a son-in-law that's an electrician. I'll ask/have him do it. Sent from my iPhone using Tapatalk

No, I don't

After installing my VS Pump I left for a week to visit family, I go home today, went out to check everything out and the Aquarite Board shows a "PCP" on the screen and all the lights are on.... I had some issues off and on during the season with the board giving me a "too Cold" reading which...

I'ts been in since Friday of last week, Iwas pretty simple to install and to program! I think I picked a winner! The bad thing is I installed it Friday, and the next day left to visit family out of state so I asked a family member to keep an eye on it make sure its running fine etc. I got home...

Thanks! Sent from my iPhone using Tapatalk

I recently installed the "Hayward SP2303VSP MaxFlo VS" and I'm noticing that I see air accumulating at the top of the strainer cover. It goes away at higher speeds but returns at lower speeds. My old pump was not variable speed so I didn't see air in cover after about a minute of starting...

I was asking if anyone had any personal reviews on this. I installed it and it seems to doing quite well. Sent from my iPhone using Tapatalk

I don't have a cleaner. Just vacuum/brush etc. Sent from my iPhone using Tapatalk

I'm about to leave for a week, and though my daughter and son in law will be around, I'd really like to just "set it and forget it" until I get back. Any recommendations on amount of time it should run at higher speeds? At speeds lower than 850 RPM my low flow light will come in so I set...

I just today added a Hayward max flow IS2393VSP2 on my SWG pool. I have the directions on how to program the timers but I don't have the knowledge on what times and at what speeds for the pump to run. Should it run 24/7 and at times a very low speed? Or 12 hours with various speeds- these...

I just checked, and I do have 10 inches a straight pipe going into the pump as it is set up right now.

One thing that helped me decide on this pump is thy according to the schematics it may not require any re-plumbing. It appears that the inlet and outlet are within 1/4 inch or so of my present setup. I won't know for sure until I get it in hand but it looks like it might work with little or...

I just ordered this to replace an aging and deteriorating sta-rite pump- I looked at reviews and they seemed pretty reliable and highly recommended. Does anyone have any experience with one of these?