Recent content by kendjelic

I currently use what you suggest above except two scoops of 870 which is the same as the OP as well. Should we only be using one scoop when testing only 10ml?

Makes sense. I check it every night so as for now I'm on top of it. Do my other figures look ok?

Regarding the CYA, I drained about 12-16 inches from the pool yesterday and refilled with our hard tap water as the pool was originally filled using our water softener which was a mistake hence my adding 14lbs of hardner. My test were reading my CYA at about 100-110 consistently so was hoping...

Yeah last night at about 1am the FC came in at 10. Water looks beautiful. The attached picture was just taken looking in at the drain.

Well it looks like perhaps I may have not waited long enough to take a water sample as I took it from the inline spigot and not from the pool itself as I normally do. Either way, it looks like the chlorine is holding fine now. Here are the test results from both kits as requested from 8:30am...

I will post results tomorrow morning. Everything was perfect since the increaser addition. Also is there a reason I shouldn't test with the ColorQ Pro? My results are almost exact to the K-2006 results. Only numbers off by only a couple ppm are the CH and CYA test, all other tests are exact.

Hello, Today I added about 14lbs of CH Increaser to my pool as it was originally filled with soft water testing at around 80ppm. My goal was to raise it to around 200-250. Now my concern is that since I have added the increaser I can't seem to manage my FC level. It has been dropping a few...

So I received my K-2006 kit and my Calcium Hardness increaser today. I drained my pool about 16" today and my CYA seems to have decreased from about 100 to 70. Still more to go but at least that's a start. Also this was a great time to test my ColorQ Pro against the K-2006. The ColorQ...

Perfect. Thanks for the quick reply! Time to lower this dang CYA.

So this morning I just started to pump out some pool water via my built in spigot. The pump is currently running at 3300 rpm and only pulling from the main drain. My concern is since the in-floor cleaning system runs when the pump is on, should I be worried when the water level drops below...