Recent content by Judodad

Yes, I had about 3.5 lbs left from the spring. I’ll prob need another 3.5 lbs. Other than that I suppose everything else is good? I did add some baking soda to bring the TA up some. Thanks

PH - 7.8

Here are my results today. I’ve added baking soda and stabilizer. See anything that doesn’t look good?

That’s fantastic. Thanks, Gene

Jim, FYI and I’m sure you already know this. I cut the white wire on the flow switch which is the temp sensor and now it reads correctly. That for sure confirms a bad temp thermistor as it defaults to 77 degrees. I’ve learned a lot from TFP over the years and just found an article in the...

Ok, that makes sense to me. Thank you much!

Another question. If I order a replacement flow switch, will an off brand like Excelfu be as good as OEM replacement or should I get the OEM Pentaire switch? Thanks

Thank Jim. Will another brand SWG work with the Pentaire system? Just curious, if there’s a known problem with them if I should get a better one that will last longer. I’ve been through 3 SWG’s in 11 years so don’t know if that’s normal or about on par with expectations.

Is it normal for a SWG to read lower than what the Taylor K-1766 test reads. I have the Pentaire IC40 with Easy Touch system. The easy touch diagnostics shows 2450 ppm whereas the Taylor K-1766 shows 3600. Big discrepancy. If I add more salt to get the SWG to where it needs to be in order to...

Found out that they added Start Up Tec during the fill. This stuff is amazing! There was no dust whatsoever.

All is good in poolville, 😂. Got my CH to 250. Just added stabilizer. Brushing 2 times a day but not much dust at all. I think the sequestrant and the fact I’m keeping my PH between 7.2 and 7.5 is helping with dust or they did a fantastic job on the acid wash.

I’m in charge of the start up. They did an acid wash on the pebble sheen before filling and that’s it. Yes, I’m using bleach for chlorine.

I just had my pool remodeled. Our pool is 11 years old. We just had the prism blue pebble sheen removed and went back with blue surf pebble sheen. I just started up the pool yesterday afternoon. Sequestrant was added. The CH is only 75. PH is 7.2. TA is 80. Will be adding stabilizer this...

Water is clear, salt is 3500. I was thinking the same thing after plugging it in to the pool math calculator but I wanted to make sure I wasn't overlooking something. Thanks for the advice guys!