Recent content by jhmanqso

Just found a split in Tubing.

The air tubing runs from the box into the short pvc pipe.

I removed the air button but the tubing was not attached. It appears the pool builder had ducktape at the end of button but tubing no longer attached. It may have blown off with the pressure of the blowers coming on at full speed by themselves twice. Any ideas how I can retrieve the tubing to...

Thank you. I will try that first.

My spa blowers have turned on twice by themselves while in pool mode. They came on at highest speed. Air button not functional to turn off. I had to turn off at breaker in order to shut them off. Has anyone experienced this? Could it be the air button or something electrical? Thanks in advance.

Has anyone found a solution to this problem? I have a jandy lite2 model LJ doing the same thing. Spa only heats Between 99 to 100 degrees when set on 104 degrees. Any help would be appreciated! - - - Updated - - - Any solutions to your issues. I am having the same issue. Thanks

Thanks everyone, I bought the tri sensor and everything is working great.

I did get 2 of the displays 11 and 0A then the 172 pop up.

I unpluged the adapter board then plug into the main board. Now service light is on and error 172 and 186. Do you think this narrows it down to the Tri sensor needing to be replaced? I just hate to spend money on the sensor if it is the boards. Thanks again for all your help!

I went back 45 minutes later and no indicator lights on and "no flow" light in LCD again. Appears it just stays on for a few minutes. I will try taking the adapter off and see what happens. Thank you so much for your help. Is the adapter hard to remove?