Recent content by Jayryght

Thanks perhaps a high wind chimney kit then. And if that doesn't work; an active exhaust fan kit. I really can't afford a shed right now...

Just an update regarding this three years later. Got the heat exchanger cleaned about a year after this happened and still rolling out. The tech said it wasn't all that dirty. Heater just rolled out again after a touch of wind. Control panel went at the end of last season so I replaced that...

Just an update regarding this three years later. Got the heat exchanger cleaned about a year after this happened and still rolling out. The tech said it wasn't all that dirty. Heater just rolled out again after a touch of wind. Control panel went at the end of last season so I replaced that...

Thanks @PAGirl ?

Replace either before the end of this season or beginning of next. I would see if you can get it done now actually; you can probably get a good deal for the end of the season. If not, I agree with the other two people who commented--patch and replace next year.

Hi, I have a pool that was built about 35-40 yrs ago that I reno'd in 2012--Rust proofed panels (metal underneath liner); replaced liner; coping; pool deck; sand filter; pump motor and heater. Recently, I noticed that in the deep end of the pool in one of the corners (it's an old style kite...

@wjr75 Thanks for the tip but I know verrrry little about electrical work and I don't even know what an alligator clip jumper wire is. At this point I may bite the bullet and call a tech. Kudos for your help though.

Re: Raypak heater "Rollout SW Open" @wjr75 How do I do that? "Jumper across the rollout sensor?" - - - Updated - - - @pool clown: no I did not replace it. Not sure how to do that? I see the wires tracing up towards panel, but I guess I have to take off the panel to see it's...

I tried that. It doesn't even ignite. Nothing happens. It is just the error message.

Was wondering if someone could please help me out on this; I have a Raypak Natural Gas Heater (auto start) bought and installed in 2013 and just turned it on to heat the pool and it's reading "Rollout SW Open". I have read elsewhere on this site someone having a similar problem and have...

I have the same problem. Just happened to me today. I bought and got my heater installed in October 2013 and it heated the pool really nicely. I haven't used the heater in about a week. It's been really hot in Toronto. Today I wanted to do an evening swim with the kids and my wife so I...