Recent content by janosik81

I could make few more and ship it to you... I guess...

Yes my plug is behind winter cover . i replaced it with skimmer return nozzle/jet. First i installed my plug , rubber gasket stayed in place. Later i blown return line from skimmer to filter(filter was disconnected before... Of course). When return line was blown i installed water gate and then...

i did it.. pool closed.. here's pictures of adapters/plugs i made to connect compressor, and here's picture how it looks from inside pool

Did they drain water below skimmers? Md pipes should be fullof water on same height like water in pool. If its gona be about 2 feet in ground i dont think it will freeze

aqua genie is skimmer with return built in.. skimmer and return in one. didnt know that if i ask about blowing lines imoprtant is to inform about heater, filter... but anyway will add signature, it's just im new pool owner since few weeks..

hello!! closing pool time!!!! Everyone with aqua genies experience!!!! please share ideas how to blow them.. i'd like to use only cover for skimmers without draining water below skimmers what compressor better use(how many gallons) or shop vac??? thanks

great... thank you for help :kim: im so excited...

based on book from SWG looks like i need 550 pounds of salt, 7 pounds of stabilizer how much bleach?? if i understand correct ... im suppose to get water to the specs.. ph ~ 7 ta ~100 next step salt?? 550 lbs stabilizer ~7lbs how much bleach?? and thats all????

16x36 inground rectangle about 21000 galons, I guess ph ta gona be close to 0 because is fresh water what is filling in right now

hi!! finished DIY inground pool, right now filling it with fresh water... i got also salt system.. what chemicals am i suppose to use at the begining before start salt chlorine generator.. thanks!!

one question more about ground rod.. what distance from panel?? and ....is bonding rod with panel, pump, pool walls etc etc.. is enough or.... im suppose to lay separate wire just for rod?? awg 8 bonding wire is enough??

Circut is 240volts with 4th wire as ground. Metal pipes 6" below, compresion couplings, no threaded. All pipes going 5' and more from pool walls. Shed is about 17' from pool. Wires are 8awg thhn/thwn2. 30amp gfci breaker in main panel. - - - Updated - - - Sub panel will be outside on the wall...

Thanks jza ... house already has 2 rods separated about 6'. So i understand that shed with panel attached to wall no need extra rods? Looks like need just disconnect switch and im ready to go... Already got gfci 30amp breaker in house. I guess in shed will install regular breakers and gfci...