Recent content by isomorphic85

anyone know about how much it should cost to have a aqua cal HeatWave SuperQuiet® SQ225 compressor changed out?

got an answer on this from hayward... turns out the older HL wireless unit's are not compatible with the updated firmware

I just upgraded my omnilogic firmware and it's working but I lost my wireless connectivity to it, under alarms it says unsupported wireless bridge firmware (1.5.1) I've scoured the net trying to find firmware to upgrade the HL Wireless bridge however I can't find anything. anyone have any info...

Thanks guys.... I'm thinking I'm going to dumb down my initial parallel and valve idea and just plumb them in series as you have it... install will be so much simpler and less to go wrong down the road with valves. If I plumb them in series as in the diagram do you see any negative effects from...

what would your suggestion be as far as plumbing a heat pump and gas heater? am i understanding correctly ... your saying plumb them in series with the heat pump first?

so in my diagram below I have the heaters in parrallel with each other.... on the "from filter side" i'm going to put a 2 way automated valve on each input to each heater. I'm going to leave the output plumbed directly to T fittings that connect back to the pool return side. Does anyone see...

good idea poolgate... alright so i'm thinking i'm going to plumb them in parrallel with an automated valve on each input side of each heater. There is nothing wrong with leaving pressure on the return side correct? onlyjeeps... i'm not familiar with an incremental style valve. i'm sure...

Alright so the stagnant water sitting in the exchanger I shouldn't be concerned with even if it's for an extended time?

thanks for the replies... My ultimate goal is to use both heaters efficiently when possible and also gain maximum heating capacity from both when a quick rise in temperature is desired. I will be controlling both heaters with a hayward omnilogic system which will allow me to set the heatpump...

I have a heat pump currently installed and I'm adding a gas heater.... what is the best way to plumb this ? In series with heat pump first then gas heater? I've read that it's better to have water flowing through both then having water sit in one if not being used for a couple weeks etc...

Trying to decide which way to go on a new caldera spa that has the inline cartridge option for spa frog . Spa frog is releasing a new inline cartridge though in a few weeks that is chlorine based instead of bromine. The chlorine one seems more appealing as it will automatically keep the...

New York , yes usually fair amount of snow (except this year) Trees semi nearby but don't receive too many leaves from it, yes close pool for winter. I will install into paver patio. I'm very familiar with the current installation practices... however not as informed on which cover companies...

anyone else purchase an S300i online? where did you purchase from etc?

I have the pump installed it end of last year when i built my pool, absolutely love the pump , especially with my omnilogic automation controls. My only negative about the pump is that at low RPM's after a while it will develop air in the basket...i've gone nuts trying to figure out how to stop...