Recent content by fwoz

Leak is from shaft seal. Thanks

Hi, I just rebuilt my Hayward superpump SP2615X20 with a Aladin GO KIT-3 because it had a slight seal leak. Pump bearings are tight and smooth. Pump ran great and dry for about 20 hours but now the leak is back. It is very slow dripping from rear of pump below motor. No air leaks etc. Thoughts...

Thanks for your reply. All items at skimmer previously checked and OK. One additional detail - Pump strainer basket cover will burp some water when pump is shut off. Already tried two new gaskets with proper lube. Thanks, Fred.

I have a 4 year ol inground pool that developed a small air leak coming into the Hayward Super Pump. I checked all gaskets etc. Even had my pool man replace my older seperate skimmer and main drain PVC valves with a new common Jandy valve and new fittings into pump. When pool pump starts there...

I use an offline chlorinator when I'm away. I recently installes a pentait rainbow #300 off line chlorinator. The fine print suggest installing an "optional" 1/4 inch inflow check valve #R172323. I already have another 1 1/2 inch check valve after at the heater outlet. When I spoke with teh...

I had the ame problem when I first openned. If you keep shock level up and keep filter running it should turn blue and clarity will increase. Took me three days. Also, I had a bad gasket on the DE filter return so I was getting some DE back to pool. Keep this in mind you see any DE coming from...

I recently installed this feeder. The installation instructions say I should also install an optional R172323 check valve on the inlet side. My installation taps in just before de filter with outlet downstrean of heater check valve. Do I need the "optional" R172323. Thanks

I recently had a similar problem with a hayward 3620 de filter. It turned out the oring at the outlet of the de grids was bad.

Hi, I have a 3 year old H400 (propane) heater that will sometimes cut out then it reignites. I have not had it cleaned. It appears it needs cleaning of the burners/gas jets. I did check wires for contact etc. I do not have a union at gas valve. Can the jets just be removed and cleaned and...

You are so right - my fault. Thanks for the help. Look's like I have a foulty check valve, plugged inlet etc. If a quick check doesn't solve it look's like a new feeder! Thanks.

Thanks for info. looks like I have a backflow problem as I have water coming in on outlet. My feeder only has a ball check on inlet. Am I missing something. The owner's guide does not show an outflow check valve. Thanks.

Hello. I was having trouble with some algae which i quickly fuixed by shock but when it came back I noticed my hayward CL220 off-line feeder may be plugged. It appears the water is coming in through the round tube inside at the outlet side. I'm going to clean it out but would like to get some...