Recent content by flyboyusa

Hey everyone, I just wanted to check in and let y'all know some things. Since installing the Stenner and firing it up, I've had absolutely zero problems with the system! The pump and tubing is totally leak free and my FC readings are dialed in now and very consistent day to day. I've settled...

81 now. Had to drop out 1/3 and refill off my well water. Sent from my iPhone using Tapatalk

A short clip showing the first time startup and priming of my Stenner pump. I'm not sure if my video will show up ok, never tried posting a video! https://youtu.be/l4zHYoKljfU Sent from my iPhone using Tapatalk

[YouTube:l4zHYoKljfU] https://youtu.be/l4zHYoKljfU Sent from my iPhone using Tapatalk

No problem at all, I don't mind helping. You can always push the test button on the GFI with your pump running, it should kill the pump when you do, that's how you know it's being ground fault monitored properly. If you want to take a picture of the final setup I can probably look it over to...

I'd run red wire and white wire from the TOP LOAD terminals of the GFI. RED would go through your Stenner relay and then to the Stenner outlet. White would go directly to Stenner outlet. That's really the cleanest way to do it Sent from my iPhone using Tapatalk

Jumpering your hot line off the pool light relay is perfectly fine. But you can't splice into the neutral the way you have it drawn. You'll need to splice into neutral coming out of the load side of the GFI or there should be a white neutral post on the LOAD side of the GFI outlet to use. In...

Yea not sure about an outlet actually inside the box, I have a GFI outlet that is mounted through the box, at the bottom right side. Then I have one near the Stenner that the pump plugs into, this outlet is wired through the GFI, as I've drawn it. Are you planning to put your pump outlet...

Ours is 85 today, with solar cover and heater not running, northern Indiana Sent from my iPhone using Tapatalk

Hi! Sent from my iPhone using Tapatalk

Ok, here is a semi-official schematic as well as a couple pictures. Hope this helps!

The GFI outlet has both a line and a load connection points. This means you can feed straight 110V black hot leg from the breaker to the line connection in the back of GFI outlet. Then run black hot wire from the load connection on the back of GFI to the line side of the relay. Then black hot...

Yep, sure can, I won't get to it until this evening, but I'll snap some shots and make up a diagram that should be useful to you! Do you know if you have a spare, unused relay in your Intellitouch load center cabinet?

Thanks! Yes, it should be completely sealed and air tight, to avoid corrosion and loss. However, the pumping action would then pull a vacuum on the keg and collapse the sidewalls. So, I've left a thin gap around the tube where it enters the keg, I drilled the hole very slightly over sized. I...

Thanks! Sent from my iPhone using Tapatalk