Recent content by deemer01

I have a Variable speed Hayward sp2302vsp and the Digital Control Interface is not displaying anything. I do have a blue LED for Power and V2 and tested for power coming into the motor. Any advice from anyone ? Local pool company quoted me on a entire Drive install but they did very...

Glued and taped the switch where it use to go. Ordered new part. Sent from my iPhone using Tapatalk

PS0303, THANKS FO THE HELP !! I really appreciate it.

If you look at the left part it is missing the switch . It must have broke opening the door. Heater now works if i press this switch in Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Look right ? My logic is everything was working just the plastic part broke Sent from my iPhone using Tapatalk

First picture is just a black switch that looked like a reset button. Yes,The lcd will not power to turn it in until the door switch is pressed in. Yes this is a old natural gas unit. Sent from my iPhone using Tapatalk

Not seeing the tab just seeing the black button behind the lcd panel Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Ok, I took the red and blue and jumped them together. Power was completely off then turned back on. Still LO code. I am sure the Black Bypass insert and Thermal control valve are correct. Could it be the bypass valve not moving on the spring ? The old one was working but there was no Thermal...

I have the LCD on the Hayward H250IDL that shows Temp. Nothing else. Manual timer for pump power then LCD on pump motor for settings and RPM.

How do I do this ? Should it be in the Manual ?

PS0303, I followed your instructions and yes a strong stream came out of the pressure switch hole. After screwing it back in and connecting back to the red/blue wires still same LO code. Should I adjust the dial on the Pressure switch ? I have a Hayward Multi Speed pump and running it at 3000 RPM.