Recent content by dcwed

Is the low temp sensor and a high temp sensor two different sensors or one total sensor? I found where the sensor plugs into the circuit board, but I haven't checked the sensor itself out. Man, there are sensors all over the place on these things.

The error code stayed with the heater. Let me fix the statement is said earlier which was incorrect. The aqualink gives the correct water temperature, the jandy heater shows the fault and the incorrect temperature. I guess the sensor is working, but there must be something faulty in the heater...

I'll try that and let you know. Thank you for responding.

I have a Jandy heater and the aqualink is giving this error. I bought a new sensor and installed it but I am getting the same error. Is there any thing else that could possibly cause this error?

I can't help with the vinyl pool recommendation. We used Morehead pools, but they do the gunite. Sorry. They were pretty good. No particular reason that most of them are gunite as far as I know. I just didn't want to have to deal with a liner on a vinyl pool. Plus, I grew up around a...

Tell your PB to take out the combo if it is not too late. Otherwise, we had to cut the top off of the mineral cartridge to use to seal off the mineral cartridge side of the combo.

Re: First Review - Dupont Stone-Tech Saltwater Resistant Sea Thanks for the review. How has the sealer held up now that it has been about a year since applied?

What was the outcome of this thread? I am removing my Nature 2 Fusion as well and need to plug the opening the cartridge goes in. Trying to find a solution.

Was this indeed copper and what did you do to clear it up?

Did you come up with any solutions for this?

Thanks for the info. I was told to do an acid wash, but I really do not want that either. Pool is not even 2 years old.

I know this is an old thread, but there was never an update to the outcome of your problem. Sounds alot like my problem. Did you ever get this corrected and how. Thanks, Danny