Recent content by DavidHDB

thanks, I know my main is PVC and so is the filler line. Cant rule out a metal fitting somewhere underground but would be nearly impossible to find without digging up my yard and landscaping. Considering capping off the filler line and just filling with a hose from the spigot on the house.

Wondering if anyone has any other ideas about this. Could this be a corroding rebar issue? If so, is this something that my pool builder did wrong?

Thanks! Here is a picture of the valve. The supply comes from our city water connection prior to it entering the house. I will try the vitamin C. I believe the pool builder put a sequestrant during startup 7 years ago but I have never added since then. Thanks again!

Would love some help here if anyone has seen this before. I recently developed what I think is iron staining at the inlet of my pool filler. I can scrub the tile with green scotchbrite but the pebble tec is hard to clean. History: I built the pool about 7 years ago and have been maintaining...

I had my pool installed in August of 2015 and just completed my first cartridge cleaning. I noticed that two of my four cartridges have circumferential tears in the end cap. Not in the pleats or bands, in the hard rubber end cap on the top. This does not look normal, should hayward replace...

I have valve 4 unused Sent from my HTC One_M8 using Tapatalk

Thanks Hayward, could you provide part numbers for the 2 Way valve and actuator that would be good to do this, Thanks. Sent from my HTC One_M8 using Tapatalk

I used 2x the standard amount on my pebbletec and I love it. It is everywhere and it looks great but 500 for a bag is nuts. My PB didn't charge extra. Sent from my HTC One_M8 using Tapatalk

Hi, first post. I have a fill line going into my pool that runs underground back to my equipment where there is a manual valve that is used to add water to the pool. I was wondering if anyone has figured out a way to use an open aux or valve button on the Prologic to control an actuated valve...