Recent content by cthiele

@ogdento Hi Tom I seem to have the exact issue outlined in your post of 10/4/22. I had a power surge take out my Pentair EasyTouch automation controller board and once I was able to get it replaced, found that it will not sync with my wireless remote. Wireless remote firmware is 2.14 but...

Joel, thanks for the response and questions. No, I don't have the SVRS version of the VS pump. The pump never engages so it pulls nothing, neither air or water into the pump pot. I disabled the prime feature and the screen on the pump in Service mode acts like it is running but does not...

Thank you for all the suggestions. No, I first hadn't set up the unit to know it is a VS pump. I finally got to it early enough this afternoon to get through to the tech support at Pentair. Tech was very patient and helpful and all the settings seem to be correct now. However, the VS pump...

That is a good question regarding warranty. Unfortunately my dealer seems to be too busy to even come out to check it out. I didn't much in the way of documentation when it was installed. I've gone ahead and purchased a replacement motherboard/PCB for the unit and installed it this evening...

Thanks a lot, Jim. I finally had time to get back to my unit this evening and tried as you suggested and the CB still popped with all relays unplugged. Looks like I'm in the market for a new PCB. I really appreciate the direction as I've tried to call the folks who installed the controller...

We have a Pentair EasyTouch 8 control system for our in-ground pool and this past weekend, following a fairly severe electrical storm, neither the filter nor cleaner pump was working. When I went to investigate I found that the only apparent problem was that the low voltage circuit breaker that...