Recent content by crashxx

I'll check it out. Thank you.

Thats what I was thinking based on what I saw when I looked them up. Thank you for the guidance.

Well, that could be it. Looks like I'm in the market for a heater. If it were you, would you replace the entire thing, or just get a replacement heat exchanger?

I use bleach, injected into the return with a pump down stream from all equipment. We have an automatic cover so the pool always stays closed. I generally keep the chlorine levels low, or at least I thought I did.

That's what I was afraid of. This one only lasted 5 years. Its even inside. Is there a different one that has a better track record?

That's kinda what I figured. When I changed the O rings, only about 1/2 of the copper pipes had nipples on them. Unlike the picture where all of them have nipples sticking out. Thank you for the help!

I have a Pentair Mastertemp 400 that's leaking. It looked like the water manifold was leaking so I replaced all the O rings. Now I have water dripping out of the white plastic air inlet. Can anyone tell me what I need to do to fix this? Thank you all and Merry Christmas to everyone!

Interesting. They don't show it on the US site.

I guess M600 it is!

So the M600 has larger pumps than the M500?

Well, it’s time to buy another robot. I’ve had a M500 before and thought it did a great job. I see there is a M600 now. Which one is the better of the two?

The leak is from the hand nut. However, it has slowed to one drip every two or three hours. We're just going to see what happens.

Good idea, we'll give it a try. Thank you for the input.

I'm helping my neighbor install his 20 X 44 in ground pool. We got it running over the weekend but his multiport/valve is leaking a small amount where it connects to the filter from one connection. He has the TR-100 side mount filter. The O rings look fine. Does anyone have any suggestions as...

Thank you. I will try that and report back.