Recent content by camillian

Now i'm noticing the yellow service light on the heater display is flashing twice every 10 seconds or so, I think it has to be some part on the heater that is worn and is not allowing the heater to start up consistently

It is hooked up to a P4 system so the heater display always shows BP(bypass), when I have a lighting issue because of the wind for example it will show IF(ignition Failure) but now there is no code, just the yellow service light flashing every 10 seconds or so, when it finally starts running the...

it is electronic with digital display

hello when called upon my heater turns on and runs for about 3 seconds and shuts off, I then try and restart it again and again and it shuts off, I will eventually get it going for about 5 or 6 seconds then again it shuts off, eventually it will stay on and work great until we no longer call...

Not sure about any sealer that is sold at the big box stores? I did find something called Mexiglaze from Aldon Chemical for very porous stone, they have a very extensive website. has anyone heard about it?

These both have colour enhancers in them and I know the aqua mix is about $50/quart or $190/gallon so it is very expensive. I just would like to hear from others and their experiences.

I have visited a few stone places in and around my area and I found the following penetrating sealers. Aqua Mix Enrich N Seal Terra seal 4350 by Dyna Has anyone had any experience with these, I know the Aqua Mix line is sold nation wide in Canada and the USA so some of you may have had...

I removed the old sealer and even pressure washed the stone, before I attempt to reseal it I am curious to see if anyone can recommend the best sealer that will last and withstand salt water and sun.

When I built my pool in 2007 my natural stone coping was a beautiful black colour with brown and beige veins running through it. Over the years with the sun and I guess salt water the colour has turned to a dull cement looking grey and I have lost all the character of the veins also. The only...

Hi Guys, Sorry I didn't reply sooner but we were up at a friends cottage this past week. Anyway I emptied the pool to about 5 inches in the shallow end and was able to roll out the wrinkle to the side by hand. Just a note that even with only about 4 to 5 inches of water I wasnt able to do it...

Wow, I have the water down to only 9 inches from bottom in the shallow end and I still cant move it with a plunger. I will go to about 3 inches from bottom as suggested but I'm starting to get nervous about my liner losing its position as the water level drops more and more. So far it is staying...

I thought of that but worried about what some have said about the vinyl liners having a memory and the longer a wrinkle is left the worse. My Liner has obviuosly stretched to compensate for the wrinkle as it still fits nicely all around the pool wall and floor. My pool builder has been delaying...

ok i tried using the plunger with the pool full and the liner wouldnt even budge, I am now emptying some of the water. :cry:

No no, I got this wrinkle over the winter from ground water. I lifted the winter cover to find my liner floating, I have a bed of rock around the foot of the pool and a 10 inch round pipe which leads from the bed of rock to the surface. I put a pump in and drained the water but my liner didnt...

I had my water tested a few days ago, my Alkalinity was a little high at 150 and my PH was also high at 8.4, my FC was at 2.0 and my stabilizer at 40. I added about half a gallon of muratic acid and my alkalinity and ph have come down. My liner is a deep blue pebble color, I was warned from a...