Recent content by CalebsDad

Well, not being funny, but it is my pool if I get to going and it takes 2-3 weeks I will be happy just getting the leaves and muck out.

I think I know the answer, the pool has been neglected a couple seasons. And there are leaves at the bottom, and a definate swamped pool. I have been told to drain and refill. Suggestions.

I am still in process of cleaning my pool and although its been a long process I do beleive in the slam process and the bbb itself but and please allow me the but, my pool number wasn't all that bad and my decision to let me chlorine level get a little lower was not a mistake just something I...

But in the closed position It quit coming over the top of the sand filter I am lost fo sho!!!

Took off the lid to the sand filter, placed the hose into the sand bed, turned water on filled to the top. I went inside and when I came back out water was not running over the top. Is there a reason as to why? Where should I have my multiport turned to closed position?

Only when using skimmer and definatelty, is poor suction when attaching auto vac.

[attachment=0:2nwshllq]IMG_0023[1].JPG[/attachment:2nwshllq][attachment=1:2nwshllq]IMG_0018[1].JPG[/attachment:2nwshllq] http://youtu.be/WW-iD_gf04c video of when I have pool on full skimmer

So this would be underground???

An old navigator, and it uses the skimmer only. And if I am in full skimmer mode not using the vac it all seems ok but does seem to lose its strength after a bit.

This was part of another thread just wanna make sure it gets its due. All that has been taken care of, another question that I now have and it might be a no brainer but I have no brain. So when I am full skimmer, which is how I think I will need to run my pool vac the pump doesn't stay primed...

All that has been taken care of, another question that I now have and it might be a no brainer but I have no brain. So when I am full skimmer, which is how I think I will need to run my pool vac the pump doesn't stay primed as if it were on skimmer and bottom drain mode, is this normal, or...

its not coming out tried, so I purchased from HD supply to get a new seal plate and seal 75.00 total didn't think was too bad, just hope now it was the motor not the pump that has quit working

3 other bolts are missing from the seal plate on my pump, my motor stopped working last night and I have a replacement sitting here ready to go but cant get the seal plate off 1 bolt is all holding it on