Recent content by bullngator

If I bypass the heater my readings are as follows in SPA mode (with venturi T nozzles removed): 9 PSI @ 2,300 RPM @ 876 W 15 PSI @ 2,800 RPM @ 1,510 W 17 PSI @ 3,000 RPM @ 1,822 W 19 PSI @ 3,200 RPM @ 2,205 W

I removed jets. New ratings as follows. As it relates to my original statement I should clarify that jets always felt powerful. My assumption was that the opening on the venturi nozzles should be larger based on only having four jets and that this would up the performance. On another note my...

Just air from blower at poolpad for the floor pipes and jets do not feel too strong. Here are some pics during construction: http://4.bp.blogspot.com/-QCTvmcsmwq8/UEvkB7Mhx-I/AAAAAAAAAQs/o65rWl-JuW4/s1600/DSC_0555.JPG...

Full size Intelliflo VS. I have four jets in the spa and an additional return that only runs when in pool mode.

I believe so unless my eyes are playing tricks on me. http://3.bp.blogspot.com/-PntqRVRnuAM/VMQstwJaS2I/AAAAAAAAAXQ/-46MxbR-BGQ/s1600/001.jpg http://1.bp.blogspot.com/-kr9n622Yii0/VMQsu_xQdSI/AAAAAAAAAXY/6hPa8ndsoDc/s1600/002.jpg

Filter is a clean and clear 200 cartridge filter. 15 PSI @ 2,300 RPM @699 W 22 PSI @ 2,800 RPM @ 1,177 W 26 PSI @ 3,000 RPM @ 1,424 W 30 PSI @ 3,200 RPM @ 1,705 W I am also attaching links to pictures of plumbing during construction. Return lines are 2" and I believe 4" on drain line connected...

I have a 6x6 square spa with four jets connected via 2" PVC to intelliflow VS pump which is used used for both pool/spa. The venturi jets are connected to a 2" air pipe which extends approx 15' from my spa. Spa is located approximately 50' from pool equipment pad and is connected via 2” piping...

I had pavers installed with my pool just over a year ago and have not had any issues. I initially sealed the section closest to my pool + coping as I was worried about the SWG but stopped at that point as it was a major chore!

I figured this out. 1. Connect the actuator to intellitouch panel via supplied wire (valve A or B on board). 2. Go to your controller selecting Menu>Setup>Advanced>Valves 3. Select whichever valve you connected the actuator cable to (valve A or B). 4. Select "Heater" from the list...

Were you able to get this to work? I would also like to do this.