Recent content by Britishcarper

The manual did say its works with e command 4 V 2.8, mine is V2.87. Here is a link to manual. https://s.amsu.ng/yl3Fxv5LH9AN

version? I'm assuming software..V2.87. I wired I to A,B and Com then in the controller 2,3 and 4. The pump address throws me too. Not sure how to set DIP switch. Thanks for help

Just upgraded to a tristar 3202 vsp from a super II. My Super II was connected to the filter relay on my e command 4 along with my Aquarite generator. Does anybody know the correct way to wire the pump to the controller, the Vsp is compatible with the e command, but I am not sure how to set the...

Just wondering why it wouldn't be easier to do a acid demand test. Just curious if there is a reason why you dont. 10000 gallon with spa plaster with blue quartz. E-Command 4 with remote Goldline Aquarite 11/2hp filter pump 11/2hp waterfall pump Hayward gas heater Hayward fibre optic lighting

I think your CYA may be to low for your SWG, mine is 70 and I average 1.5 -2ppm chlorine a day 10000 gallon with spa plaster with blue quartz. E-Command 4 with remote Goldline Aquarite 11/2hp filter pump 11/2hp waterfall pump Hayward gas heater Hayward fibre optic lighting

What percentage are you guys running the cell at? I have my filter running from 7.30am to 6pm. I know the t-15 is good for upto 40000, my pool is 10000 so maybe I should run at 30% and check pool when filter turns off Sent from my SAMSUNG-SM-G935A using Tapatalk

Been following this site since I had my pool replastered 5 wks ago. The past 5 wks I've been treating my pool the TFP way and using the pool pal app with TFP configuration, my balance has been great and the last week I've started increasing CYA, I'm currently at 60ppm. I added salt Friday and...

Sent from my SAMSUNG-SM-G935A using Tapatalk

Wiring in the manual is pretty straight forward, just shows how to wire relays for 220v or 120v, i have to supply breakers for the box. Just wondered if i could have pump and heater from a 20amp breaker then other pump and blower on another 20amp breaker. Do lights need to be on gcfi with them...

Hi guys, been following this forum with interest and learning alot about pool chemistry. Im in the process of upgrading my control unit, my e- command 4 has just arrived and have a question about relay and breaker wiring. I have filter pump 220v 9amp 1.5hp Water fall pump 220v 9amp 1.5 Blower...