Recent content by boysovsumr

We are going to replace the cord to be in compliance. My disgust was that I was under the impression that the inspection was for the water bond and the locking boxes.

OK, had everything done as shown in picture, inspector came out . . . .said he can't slap sticker on cause we are using a 1 hp filter with regular plug as opposed to twist-lock plug (earlier post mentioned that our 1 1/2 hp filter stopped working so we got this one for a replacement). We have a...

Here is the pic of the water ground. . . .a wire attached to the skimmer. Apparently the wire all around the pool and the grounding of the electrical box/filter wasn't enough for an above-ground pool. Anyone heard of such idiocy?

I have an 18 x 33' above ground just put in. The long side on right is going to need a retainer wall, we have that in mind. After that, what is the best to put down all around pool? We were tentatively thinking plastic, then pavers and finally heavy stone. Does this sound right? It is to be...

Thank you!!! I will question the inspector again.

Hi! We had a new 18 x 33 pool installed and had to have copper wire run all around it, being grounded near the pump per township regulations. Now they say we have to have some sort of clamp attached to a hose and put in the ground - referred to it as water ground. They assured me any pool...

No, it does not have a switch like that. Cannot find a capacitor at all . . . .so must be one that doesn't have one, but thanks for responding. Just frustrating, cause it was working fine until a couple days ago.

Hi, I'm new here and we have an 18 x 33 above ground pool. Our pump is 1.5 hp waterway supreme and has stopped pumping, just hums. I have taken cover off and can spin impeller, so according to others that means engine hasn't seized. Looking for the capacitor, I am at a loss. Took to pool...