Recent content by Bmill

Thanks James, so do you think I’m ok?

Here is a harder one for you. Pentair 400 controlled by newest version of I Aqua Link. One day my phone app will not turn on the heater. On the app it looks like it is on but it is not actually on. App controls everything else fine. Heater would not start from the heater touch panel either. My...

I did have the same issue, my Aqualink is a bit newer but in the end we made it work. Look in the manual and see what types of pumps your version supports or call them. Pentair has many models but only two electrical packages. When I started with my issue members of the board said to hang in...

This still is a mess, everyone says the controller should see it as a VS pump. Now Pentair is saying the wire colors need to be miss matched... I'm going crazy!

Interesting development on my Hayward heater, I have American Home Shield appliance warrantee. They came out today and replaced the motor, control board and, igniter for the $60 deductible! Know anything about a Compupool salt cell as a replacement cell? The review seem good by my a niebor guy...

So I have a bit of a mixed bag pool system in Ca. A Jandy RS OneTouch control, a Pentair IntelliFlow pump. Along with a Hayward salt system and heater. The salt cell and control board are dead. Heater is on its last legs. So what should I purchase? Pool is about 15000 gallons. Easy of use and...

So I have a bit of a mixed bag pool system in Ca. A Jandy RS OneTouch control, a Pentair IntelliFlow pump. Along with a Hayward salt system and heater. The salt cell and control board are dead. Heater is on its last legs. So what should I purchase? Pool is about 15000 gallons. Thans guys.

Yes it did, sorry about being a bit slow on that! So far the issue seems to be the Aqualink will not recognize the pump. Rereading the manual, there are 16 pump addresses and it seems per page 10 of the manual not all controllers recognize all. But I think I found the issue, per the Jandy...

Thanks Jason , the one touch was purchased in December, version 11 of the software. From everything I read I should not need a Intellcomm. Not sure about a data cable, what is that? So far the One Touch will not find the pump.

I own both. This weekend is the big installation attempt !

Long story, but i own the above controller and pump.

I there I'm a new pool owner and I am busy reading all I can. My new house has a brand new Aquilink OneTouch control unit with the the WiFi app. But the pump is very old and I would like to replace it with a IntelliFloXF. Right now there are actually two pumps one for the water feature and one...