Recent content by Bink

OK, going to the store now for Borax. Will update again in a couple of day's. THANK YOU!!

I have the TF100 kit, that is what the numbers are from. Wasn't sure if my PH was low because of all the shocking I had done. Should I get the PH up first then go back to shock level with the chlorine? I went ahead and turned the filter back on. Didn't get the bottom as clean as I had hoped as a...

While it has taken a week I am finally winning the battle of the swamp. Got the water to the milky state and it appears that the algae has been beaten back. Since the water was still not clear I decided to flock it. I had a bottle already so I just followed the directions, unfortunately it did...

Got a new water inlet installed last night and suction is where is should be now. Will probably be posting about my algae next....just started chemicals today. Thank you for the help. :cheers:

I just did mine this past weekend, I drained the water out first. Disconnected the hoses and valve and just tipped the entire filter over on it's side. Simply scopped the sand out from there. Was even faster than using a shop vac which I had done previously. Just be careful with the plastic...

Still a newbie to this site but need some advice as to why the suction is so high at my skimmer. I have a 24 ft round ABG with a Jacuzzie 192 sand fillter (holds 200 lbs of sand) with a 1 hp pump motor. Pressure is so high that if a couple of leaves get sucked into the skimmer the suction will...

Close this one out, not sure what happened but after dropping the unit accidently it appears to be working again. Go figure......

Just tried moving the timer, still bounces from light to light....just takes longer for it to start. Shouldn't the test light indicate power at the outlet? It's just a simple AC/DC with test leads that lights up but I get nothing. Does a manual exist for the for the transformer other than the...

I have a Pool Rover Jr. that is about 4 years old. Ran it for the first time yesterday and it was fine. Tried to run it today and nothing happens. It appears to be the transformer as the power comes on, I hit the reset button and after a period of time the light will start switching from the top...