Recent content by Billynas

I’m about to tackle the same issue and was wondering if the leak stopped. Also, where did you get the materials/parts?

Yes it's been high over 90f. Interestingly, over the last few days it's been around 86f and the amps are below 8 even with a salt level of 3700ppm. I think you're correct about temp affecting amperage. Thanks!

Thanks, I'll lower the salt to 3000 to 3200 and see if it works properly. In Water balance for SWG, it says to start with 200-400 above optimal salt level hence my calculation of 3600...no worries.

My new chlorinator keeps shutting off and saying High Salt/Amps. I spoke to Hayward and they said the sensor can be +/- 500ppm. I've tested with Aquachek strips and get 3620 consistently. I can reset the chlorinator and it will be fine for awhile then I recheck and it's off again. Readings are...

Thanks, I'll recheck in a day or so, expecting rain tomorrow also.

OK just coming off a slam and chlorine and pH are still pretty high should I wait until chlorine drops to add acid or try to get the pH down and just let the fc Drop on its own using SWG water is pretty clear and here are my numbers FC 11 PH 8.2 CC 0 CYA 70 TA 100 Salt 3900 SWG set at 25%...

Thanks that could explain why I have cloudy water during peak demand months I contacted Hayward technical service and they said the 15 is the only one they recommended

I'm about to change out my salt water generator for the third time in eight years . my installer put in a Hayward T cell five for my 19,000 gallon pool running off an aqua plus digital controller. I've had clear water running 8 to 10 hours per day unless it gets real hot in the middle of the...