I took most of the heater the scrap yard today but I kept the gas valve and burner assembly, both vacuum valves, wire harness and manifold. Let me know if anyone needs any of these parts.
Yes, I will, I can bring it by this week if you would like. PM me your number, I can bring it by sun, tue, wed or Thursday. I am a little limited for time on sun but maybe we can make it work.
I have a used heater as stated above, the heater core and blower are both not good. I decided to replace with a new heater so if anyone needs any parts make me an offer and loacation and I will get back to you. I am located in Las Vegas.
Thanks
Thank you for the quick reply. i do not use my heater that often, summers here in Las Vegas are a killer. is it recommended to not have water flowing through the heater constantly?
Hello
I am looking for a little advice on plumbing up my new heater, it is a hayward H400FND, it replaced an older H400HDL. So as you can see by the picture the manifold spacing is wider on the new heater. I'm hoping that two 90 PVC elbows will do the job for for sides. I will buy a bunch of...
I recently had some paver work done and a gas line run so now i am looking to build the firepit. I have been researching a lot on the net and all the sites seem to have a lot of the same stuff. I keep coming across kits from http://www.hpcfire.com I was wondering if anyone has ever used these...
Re: Need help ASAP - Rusted ground lug on inside of light ni
They make tools that can remove broken screws/studs etc.they usually attach to a drill and bores the inside of the screw out. If you can't get the screw out see if you can find a grounding clamp that can attach to the lug. Just make...