Recent content by beef

OK, I will wait for warmer weather and use bleach for now. Maybe I opened a little too early this year! Thanks for all the replies..

After initial power up and set to "Super Chlorinate": 3200 52 27.1 4.77 100P -3200 AL-1 r1.4 20 minutes later: 3200 52 33.7 0.04 100P -0 AL-1 r1.4 So for about 15-20 minutes it generates, sometimes not even that long. Cells look very clean, flow is good.

The water temp is hovering around 50-52 degrees. Usually the code "COLD" appears around 50 degrees and below. So maybe it is not generating, and not throwing the code?

No other error codes present, all looks normal. Set to 100%, also "super chlorinate" setting reacts the same. After initial power on, generates like normal then 5 minutes or so it stops generating. Lights do not change. Will the system stop generating after reaching a certain chlorine level, or...

No other codes or error lights. Unit is set at 100%, this also happens when I set to "Super Chlorinate". It will only generate for a few minutes (you can see the micro bubbles in the cell). I understand the unit works off a percentage of time per cycle; does the system stop generating when it...

I have an AquaRite SWG that won't keep generating chlorine. After initial "on", the unit will generate with an amp reading @4.42, however shortly thereafter it stops generating and the amp reading drops to @0.02. The control is 8 seasons old, and the cell is new last season (2014). The system...