Recent content by adicted

All it needed was that seal and primed right up

well i had no luck again getting this started. I noticed some drips coming from a connectins on the intake end. I unscrewed the connection and noticed that there was no gasket. I called The Pump Co. up and told them whats going on they saiyd come on down and get it. Too bad they closed 10 min...

i found a problem. If you look at the picture i posted just to the right of pump is the first connector. Its having a drip right there. Do you think that can stop it from priming...

Hey guys and gals, been lurking for a while but it was time to post. Love the site and all the info. So I'm having an issue. Pool is about 5 yrs old. So my motor bearings and parts of the pump went out. Took both in to get repaired. They replaced bearings, impeller, etc. Went home hooked...