Report

mknauss

Mod Squad TFP Expert Bronze Supporter

Mod Squad From Laughlin, NV

Joined: May 3, 2014

Last seen: 37 minutes ago Viewing thread Gamma Venturi Pop up heads - Thoughts?

Start conversation

Latest activity Postings Media Albums About

- mknauss replied to the thread Need confirmation on my wiring for IC40.
  
  Bottom right of the login page.
  
  Today at 7:17 PM
- mknauss replied to the thread Need confirmation on my wiring for IC40.
  
  Jim is showing a page from the PC based Screenlogic Connect, in the Configure ScreenLogic section.
  
  Today at 6:55 PM
- mknauss replied to the thread Help balancing.
  
  That is stabilizer. Albeit not much. Get FC to at least 3 ppm.
  
  Today at 5:52 PM
- mknauss replied to the thread Help balancing.
  
  Have you added any stabilizer of any form? I would suggest getting FC to at least 3 ppm. But up to you.
  
  Today at 5:49 PM
- mknauss reacted to dct's post in the thread Pool Too Full with Like.
  
  I was trying to avoid that. I just had the pool built, I guess another hundred or so is a drop in the bucket. Thanks!!
  
  Today at 5:42 PM
- mknauss replied to the thread Help balancing.
  
  It is a DPD test. Color matching. Not accurate and it cannot go above 5 ppm TC. I believe once you try to purchase the CYA and FAS-DPD...
  
  Today at 5:35 PM
- mknauss replied to the thread Pool Too Full.
  
  You can pinch off the return valve but I would not close it completely. You should consider getting a sump pump for these times.
  
  Today at 5:29 PM
- mknauss replied to the thread going away for 6.5 weeks, should I close the pool and reopen it or get somebody to keep it running?.
  
  How do you cover? You may get a code enforcement citation if the pool is green for too long.
  
  Today at 5:19 PM
- mknauss replied to the thread Help balancing.
  
  You also need the FAS-DPD test kit. R0870 powder and R0871 reagent for FC testing.
  
  Today at 5:18 PM
- mknauss replied to the thread Preparing to open in St Louis.
  
  Welcome to the forum! I suggest you read through Pool Care Basics - Trouble Free Pool and even look at a few of our videos TFP-TV -...
  
  Today at 5:16 PM
- mknauss replied to the thread New and starting out.
  
  All good. The pH is above 7. So that is fine. TA will push that up over time. FC is great. Keep it in target range using
  
  Today at 3:26 PM
- mknauss replied to the thread Pentair IC40; No lights on salt cell.
  
  Jim -- the breaker is popping with the IC40 disconnected, Even with a new surge card ------
  
  Today at 3:17 PM
- mknauss replied to the thread Pentair IC40; No lights on salt cell.
  
  If with the IC40 disconnected, then I believe that would imply the Surge board is bad. I would remove all the RS485 connections on the...
  
  Today at 2:37 PM
- mknauss replied to the thread Pool looks like a pond lots of algae.
  
  Looks like dead algae. Brush and vacuum the pool daily. Follow the
  
  Today at 2:33 PM
- mknauss replied to the thread Water level in the DE Quad filter tank.
  
  Did you open the air release valve on top before undoing the clamp?
  
  Today at 2:29 PM
Show older items
Loading…
Loading…
Loading…
Loading…

Top Bottom

Back

Search

mknauss

Find content

Latest activity Postings Media Albums About