C
Report

cmiller73

Well-known member 50 From Houma, LA
Messages
262
Media
38
Featured content
0
Reaction score
19
Points
0
Joined
Last seen
Follow
Start conversation

Latest activity Postings Media About

    • C
      cmiller73 replied to the thread Dolphin E10.
      IIRC about 6 or 7 years.
    • C
      cmiller73 posted the thread Dolphin E10 in Pool Cleaners.
      Been having it a while. Noticed today it doesn't want to move. Inspected it and came to the conclusion the drive system is shot. Main...
    • C
      cmiller73 replied to the thread Pentair SL PA.
      Here is a pic while it is connected directly to my PC. That light indicates ethernet is connected. Other light is off because I cannot...
      • 1711126238441.png
    • C
      cmiller73 added the media item 1711126238441.png to Pool Equipment.
      1711126238441.png
    • C
      cmiller73 replied to the thread Pentair SL PA.
      The 2 little light next to the ethernet port on the PA.
    • C
      cmiller73 replied to the thread Pentair SL PA.
      New router will be here tomorrow. I did have to change the IP range and DNS on the previously meshed router that I tried for now. I do...
    • C
      cmiller73 posted the thread Pentair SL PA in Everything Else.
      Read a ton of posts but nothing really mentioned my issues. Over last weekend we had a lightning strike that fried my main router. The...
    • C
      cmiller73 replied to the thread Heater settings.
      That makes sense in the event it was on a schedule. If I turn it on, then it could. Either way, the pump could start up 1st to get...
    • C
      cmiller73 reacted to ajw22's post in the thread Heater settings with Like Like.
      No it does not. If the pump is not running the heater does not have a good water temperature reading. The automation and heater only...
    • C
      cmiller73 replied to the thread Heater settings.
      Looks like the upgrade panel would cost about $1k.
    • C
      cmiller73 replied to the thread Heater settings.
      To be fair, I didn't know the difference between ET and IC at the time. I never had a system like this. Guess I should have done a bit...
    • C
      cmiller73 reacted to ajw22's post in the thread Heater settings with Like Like.
      It is disappointing that installers are selling obsolete EasyTouch systems when the IntelliCenter is available. And that they do not...
    • C
      cmiller73 reacted to ajw22's post in the thread Heater settings with Like Like.
      The heater puts out a fixed amount of BTU's regardless of water flow rate. Faster flow gives you the feeling of lower exit water...
    • C
      cmiller73 replied to the thread Heater settings.
      Here is how my panel is wired. Yes pump/IC is on Aux2, but behind mb the connections are swapped with 1 & 2. And, @ajw22 , as you can...
      • 1710421115399.png
    • C
      cmiller73 replied to the thread Heater settings.
      Yes. I have. User manual says 40gpm min. I have my pump set just above that. So at this time, if pump/IC circuit is on, I can turn on...
    Show older items
  • Loading…
  • Loading…
  • Loading…
Top Bottom
Back