Latest activity Postings Media About
-
-
mas985 replied to the thread High Pump Discharge Pressure 25+ PSI.I seriously doubt the pressure was ever 10 PSI with an in-floor cleaner and that size pump. 25 PSI is a reasonable filter pressure with... -
mas985 replied to the thread Hayward Powerflow Matrix tripping breaker.Is the pump motor making any sort of grinding or screeching noise? Bad bearings will increase the current load on the motor and trip the...
-
-
-
mas985 reacted to Bperry's post in the thread High FC and TA, What should I try to tackle first... with
Like.
Id second this recommendation. 350ppm is really high and something not seen often. Maybe post a picture or video of the test for a... -
mas985 replied to the thread Failing T-15 SWG Cell Experiment.Maybe if I had nothing better to do and owned a plumbing supply warehouse.
-
mas985 replied to the thread Failing T-15 SWG Cell Experiment.From my perspective, if a single cell were not able to keep up, I would just replace the cell. Too much work vs benefit.
-
mas985 replied to the thread Failing T-15 SWG Cell Experiment.Why bother? T-5 Mode works perfectly well.
-
mas985 replied to the thread High FC and TA, What should I try to tackle first....With current FC levels, I would shut it off until FC drops. Without any alarming the SWG is fine, no worries. It will drop with rain...
-
mas985 replied to the thread Failing T-15 SWG Cell Experiment.So why is that a problem? There is plenty of warning before the cell completely fails in T-5 mode. At <2700 ppm salt reading, a low salt...
-
mas985 replied to the thread High FC and TA, What should I try to tackle first....Turn on the SWG and see if it alarms. The unit will shut down on it's own if it is too high. I don't think it will be an issue at the...
-
mas985 replied to the thread Failing T-15 SWG Cell Experiment.Yes, I am configuring the controller for a T-5 cell (smaller) even though the old cell is a T-15 model (larger). As SWG cells age, they...
-
mas985 reacted to ajw22's post in the thread Hayward T-3 working but still reads low PPM, why? with Like.
Check that the cell type is correctly set int he controller.
-
The other day I got curious. I know there are three houses with pools right in a row up the street from me. So I started looking...
-
mas985 replied to the thread Hayward T-3 working but still reads low PPM, why?.Usually, it is one of two reasons: 1) Dirty cell. Remove cell and inspect for calcium deposits. If dirty, clean. I use bamboo skewers...
-
-
Loading…
-
Loading…
-
Loading…
