Latest activity Postings Media About
-
-
mas985 replied to the thread Gamma Venturi Pop up heads - Thoughts?.The claim is that they allow for lower flow rates for the same effective cleaning as the original heads. The claim is reasonable given... -
mas985 replied to the thread What size pump?.An equipment controller is an electronic box that has a display unit with several buttons that are used to turn on and off pumps, pool...
-
Yes it did. It's still dissolving. I'll recheck tomorrow and reset the cell. I hope that's what the problem is. I'll let you know...
-
mas985 replied to the thread Salt cell temp sensor error message.Did the salt land on the main drain? If so, it could introduce very high salt concentration into the cell. Is all of the salt dissolved...
-
mas985 replied to the thread Salt cell temp sensor error message.That could indicate the temp sensor may be shorted. What is the cell temperature in the diagnostic menu? How long did you wait after...
-
mas985 replied to the thread Aqualink re-prime on Solar?.There is much less heat delivered to the pool during those hours due to a lower sun angle plus a lower panel efficiency due to lower air...
-
mas985 replied to the thread Aqualink re-prime on Solar?.Just seems easier to start the pump a little after the sun first hits the solar temperature sensor so they both start at the same time...
-
Spoke with Fluidra rep, he said there is no way to do what I want. Although I did have to explain to him the basics on how the solar...
-
mas985 reacted to huberdude's post in the thread Waterway Spa Jet - All jets except one have air pressure and with pump and blower running with
Like.
I'm running 8 Polystorm jets. 2 lower and 6 upper. I did have the single jet having the issue purged. I'll try doing all of them next... -
mas985 replied to the thread Waterway Spa Jet - All jets except one have air pressure and with pump and blower running.Usually, the issue is a blockage in the jet. Remove ALL of the fittings AND nozzles and run the pump without them installed, it may...
-
Thanks for the calculations Mark, I will give that a try. I'm planning a replumb of my equipment with a heater bypass, fewer hard 90s...
-
mas985 replied to the thread Aqualink re-prime on Solar?.So with that pump and an estimate of the plumbing you might have, I get a filter pressure of around 5 PSI at 1700 RPM & 9.6 PSI at 2200...
-
mas985 replied to the thread Looking for a Jandy WFTR160 replacement.Although the WFTR160 is classified as a waterfall pump, I don't think it is exempt from the new DOE regulations. This shows it as...
-
Shoot! I had Gap Time at 50. I apologize.. Guess I missed that while focusing on loading the script. Changed to 10 - original script...
-
mas985 replied to the thread AQL-PS-8 Remote Emulator App.Also, on the setup detail page, what do you have for Gap Time?
-
-
Loading…
-
Loading…
-
Loading…