Latest activity Postings Media About
-
-
JThis would look cooler:
-
JJamesW replied to the thread Standalone vacuum pump.Put a valve on the discharge (Not the suction) to control the flow rate. This allows you to control the suction as well as the water...
-
JJamesW replied to the thread Does this make sense?.You should not have your Polaris suction intake before the flowmeter. Does the pump flow reading match the flowmeter reading? What...
-
JJamesW replied to the thread Featured Copper source? Hair turning green.You can look into the fittings to see if there are any signs of corrosion.
-
JJamesW replied to the thread Does this make sense?.An 8 hour turnover is about 85 GPM. DE is rated at 1 gpm/sqft, so you need at least 85 sqft of DE fiter. For cartridge, you need at...
-
JJamesW replied to the thread Does this make sense?.Commercial pools have to meet turnover requirements and flow rates. What is your required turnover time and required flow rate?
-
JJamesW replied to the thread Failing T-15 SWG Cell Experiment.It's pretty simple. Just make a manifold like this and install up to 24 cells. You can use valves and valve actuators to open and...
-
-
JMaybe if I had nothing better to do and owned a plumbing supply warehouse.
-
JJamesW replied to the thread Salt cell temp sensor error message.You could use an external temp sensor and connect it to the red and blue wires going to the plug. This is a hack that is not approved...
-
-
JJamesW replied to the thread Salt cell temp sensor error message.1E19 means 1 year warranty made in 2019. The cell is over 4 years old. Check the resistance of the thermistor. Holding the plug...
-
-
JAmen to that !! It was second nature at the old place.... open, 2 weeks 4 weeks 6 weeks 4 weeks 2 weeks close. At the new place...
-
-
Loading…
-
Loading…
-
Loading…
