Latest activity Postings Media About
-
-
JJamesW replied to the thread Deposit before groundbreaking?.It’s important to remember that trust goes both ways. Every person who owns a small business has had customers who do not pay what they...
-
JJamesW replied to the thread Perfect Filter Drain Mod.Something hard and flat that fits perfectly without a gap and without pushing up on the part. It can happen when you least expect it.
-
JJamesW replied to the thread Help understanding the difference of quotes.If the equipment will be far from the pool (Over 80 feet) or if it will be elevated higher than the pool, you have to revise the pipe...
-
JJamesW replied to the thread Help understanding the difference of quotes.Make sure that you get at least 2 skimmers and maybe 3 or 4 depending on how much leaf debris you will get. Are you getting a main...
-
JJamesW replied to the thread Small Rust Spot on Stainless Steel Panel of Above Ground Resin Pool.It might be from galvanic reactions or maybe just scratches from vibration. Clean and patch as best as you can. Maybe cover with a...
-
J2" or 2.5" plumbing is adequate for most lines unless you have something that has high flow needs. 3" pipes get you into a higher cost...
-
JJamesW replied to the thread Help understanding the difference of quotes.Going all 3" does not make sense. Follow the velocity rules. For skimmers, you will never put more than 60 gpm on a skimmer, so 2" is...
-
JUPDATE It has been a while since I posted last but this old cell is still running strong. Current is a little over 3 amps at around...
-
JJamesW replied to the thread Copper cyanurate?.https://www.troublefreepool.com/threads/purple-indigo-algae-sticking-to-steps-and-bottom-of-pool.273324/
-
JIn 2021 when we shopped we were still fighting some of the COVID Pool buying craziness sadly. We sat down with 5 large reputable...
-
JJamesW replied to the thread Perfect Filter Drain Mod.Put something under the valve. If that gets stepped on, it will break off in a bad way.
-
JJamesW replied to the thread Pump not priming and motor making noise.Sounds like bad bearings and maybe a voltage issue. Maybe a broken off impeller.
-
JJamesW reacted to Newdude's post in the thread Cloudy Water after Stain Treatment and CYA Addition with
Like.
*checks headlines* FloridaMan added stuff that shows up as CCs. -
JJamesW replied to the thread Is this pump fixable?.https://www.hanning-hew.com/en/contact/
-
JJamesW replied to the thread Is this pump fixable?.Contact the manufacturer to see what the part is. [email protected] Go to a local electric motor shop to see if they can fix it.
-
-
Loading…
-
Loading…
-
Loading…