Latest activity Postings Media About
-
-
JJamesW replied to the thread Pool ladder anchor assembly -.If the inside of the cup is corroded, the wedge will not have anything to push against and it will not work. Most likely, you will...
-
JJamesW replied to the thread jandy trueclear vs circupool core.Can you show the label on the multiport? Does the label say Sand or DE?
-
JJamesW replied to the thread Pool ladder anchor assembly -.You won't be able to pull the wedge up unless you use a spanning washer. You need a flat piece of steel with a hole. The anchor is...
-
JJamesW reacted to AUSpool's post in the thread Accidentally lowered ph too much -- do I need to fix or can I wait? with
Like.
There is a lot going on in this thread now but I would like to make these two points. Stabilser, cyanuric acid or CyA, is not a... -
JJamesW replied to the thread IntelliChlor questions.The switch is not very accurate; it is just a piece of steel that get pushed by the water. Typically, RPM control is a better choice...
-
JJamesW replied to the thread IntelliChlor questions.If you use RPM control, a dirty filter can reduce flow. If you use Flow Control, the pump maintains flow as the filter gets dirty by...
-
JJamesW replied to the thread Pentair Master Temp 400 Heater.Exhaust Gas Temperature While running, press and hold the On button to display the exhaust temperature (Older Models). The new models...
-
JJamesW replied to the thread IntelliChlor questions.The range is 55 degrees to 49 degrees for the Cold Water shutoff. When the IntelliChlor SCG is operated in water temperatures 52°F...
-
JJamesW replied to the thread IntelliChlor questions.It's not an exact number. Just find where your turns on and then add some speed for margin.
-
JJamesW replied to the thread IntelliChlor questions.60 degrees was incorrect. Article edited.
-
JJamesW replied to the thread IntelliChlor questions.Operating IntelliChlor SCG in Water Temperatures Below 52°F When the IntelliChlor SCG is operated in water temperatures 52°F +/-3°F...
-
-
JJamesW replied to the thread Please Help Hayward T-15 and Aquarite panel showing salt levels 2000 ppm too high.Your cell is performing at about 186% of expected performance. Some cells overperform, but usually not that much. Typical...
-
JJamesW replied to the thread Please Help Hayward T-15 and Aquarite panel showing salt levels 2000 ppm too high.The cell might be overperforming, but it is probably not defective. I would just lower the salinity until the current (Amps) is below 7.0.
-
-
Loading…
-
Loading…
-
Loading…
