It is currently May 24th, 2012, 3:21 pm

All times are UTC - 6 hours [ DST ]



 Page 1 of 1 [ 4 posts ] 
Author Message
 Post subject: Just Closed, Cover Ripped
PostPosted: November 12th, 2011, 4:06 pm 
Registered User

Joined: October 29th, 2008, 5:13 pm
Posts: 23
I just closed my in-ground gunite pool in October. We had a severe snow storm here in CT the other week where trees and limbs fell everywhere. Unfortunately a huge limb came down across my pool. I had it removed, but I think that some of the smaller branches may have ripped holes in the cover. Yesterday it was pretty nice out, so I put my cover pump on top of the cover to get the water off from the snow/rain. I ran it for a very long time and when I checked on it this morning, the cover still had quite a bit of water on it and the water level underneath seems to have dropped lower than the level when I closed. Should I keep the pump going to drain the water cover thus also lowering the water underneath until the cover is water free or just leave it alone? I don't want my cover to collapse from weight, but also don't want to waste water and energy draining my pool even more if I don't need to. Thank you.


Offline
 Profile  
 
 Post subject: Re: Just Closed, Cover Ripped
PostPosted: November 12th, 2011, 10:03 pm 
Site Admin
Site Admin
User avatar

Joined: May 7th, 2007, 3:03 pm
Posts: 23779
Location: Silver Spring, MD
If the cover is leaking you need to stop pumping it out. If the water level goes too low you could have much more serious problems. It would be best to repair or replace the cover now, which will make everything easier in the long run, but that isn't strictly necessary.



_________________
19K gal, vinyl, 1/2 HP WhisperFlo pump, 200 sqft cartridge filter, AutoPilot Digital SWG, Dolphin Dynamic cleaning robot
TFP Admin. Creator of The Pool Calculator. Other handy links: Support this site, TF Test Kits, Pool School
Offline
 Profile  
 
 Post subject: Re: Just Closed, Cover Ripped
PostPosted: November 13th, 2011, 11:14 am 
Registered User

Joined: October 29th, 2008, 5:13 pm
Posts: 23
Thank you!


Offline
 Profile  
 
 Post subject: Re: Just Closed, Cover Ripped
PostPosted: November 17th, 2011, 12:20 pm 
New User

Joined: July 5th, 2011, 2:15 pm
Posts: 19
Location: Northern NJ
I was able to buy patch material and Vinyl solvent from my solid cover manufacturer. Works very well, especially if you patch both sides (top and bottom) of the cover.


Offline
 Profile  
 
Display posts from previous:  Sort by  
 Page 1 of 1 [ 4 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  


TroubleFreePool.com The Web