|
It is currently May 24th, 2012, 4:59 am
|
 |
|
 |
|
| Author |
Message |
|
azazel
|
Post subject: Hydro spa hot tub heating problem  Posted: March 26th, 2011, 10:39 am |
Joined: February 3rd, 2011, 3:59 pm
Posts: 18
|
|
I have a hydro spa tub that ia set to 104 and its only heated to 98 been two days. Is this a bad element or high limit? I have temp tub to make sure its displaying right temp and it is. What do I need to check thanks
Sent from my PC36100 using Tapatalk
|
|
|
|
 |
|
azazel
|
Post subject: Re: Hydro spa hot tub heating problem Posted: April 8th, 2011, 4:57 pm |
Joined: February 3rd, 2011, 3:59 pm
Posts: 18
|
|
Update on this. It turned out to be the heat relay. I took a cut wheel and cut the outer layer on the relay top off. Took little sand paper and cleaned the contacts and it is working perfect now. For those needing know if this could be your problem. If you have power going to the board but don't have 240 on your element most likely its the heat relay have corrosive build up on the contacts. Took me maybe a hour to open the relay up and clean contacts.
Sent from my PC36100 using Tapatalk
|
|
|
|
|
|
|
chem geek
|
Post subject: Re: Hydro spa hot tub heating problem Posted: April 8th, 2011, 11:08 pm |
| Special Contributor |
 |
Joined: March 28th, 2007, 2:40 pm
Posts: 5404
Location: San Rafael, CA USA
|
|
Good to know. Thanks for figuring this out and posting the solution so others can be helped.
_________________
16,000 gallon outdoor in-ground 16'x32' plaster pool; Pentair Intelliflo VF pump; Pentair IntelliTouch i9+3s control system; Jandy CL-340 square foot cartridge filter
12 Fafco solar panels; Purex Triton PowerMax 250 natural gas heater (200,000 BTU/hr output); automatic electric pool safety cover; 4-wheel pressure-side "The Pool Cleaner"
|
|
|
|
|
|
|
|
 |
|
 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
RSS Feed 
