Received a reply to the this question on another forum. With the difficultly found in trying to find this information, I am posting the instructions for this reset. Hopefully it helps another person searching for this procedure.
Press and hold 4 top buttons then release.
Then hold down the top two middle keys while holding down select and escape at the same time.
Turn Circuit Breaker off to the pump, wait until all the lights on the pump are out.
Turn Circuit Breaker back on, pump should be back to factory defaults.
or (I did not experience this option, after the key presses)
At Application set up press select.
To govern the pump to a 2HP or 1HP max,
press the 4 top keys,
arrow to PAR 699,
change to 1 or 2 and power down, power up.
The pump will limit the rpm to a lower setting as you limit the HP.
This is good for smaller pipe sizes so owners do not crank it up to max speed on smaller systems.