|
It is currently May 22nd, 2012, 8:48 pm
|
 |
|
 |
|
| Author |
Message |
|
jawroper
|
Post subject: Compupool LCD cycling between Testing and Verify ?  Posted: September 16th, 2011, 2:06 pm |
Joined: September 16th, 2011, 1:54 pm
Posts: 2
|
|
I has a CPSC24 installed this week. It replaced my old Zodiac LM2 system. The LCD on the Compupool is cycling between Testing and Verifying the water temperature. Is this normal? Did the installer miss configure it? The manual doesn't mention anything about how to program the unit. Suggestions?
|
|
|
|
 |
|
bobodaclown
|
Post subject: Re: Compupool LCD cycling between Testing and Verify ? Posted: September 16th, 2011, 2:54 pm |
| Registered User |
 |
Joined: April 14th, 2011, 2:30 pm
Posts: 493
Location: Lakeland, FL
|
|
After it runs the test it will show Testing and Verifying. There should also be a timer that shows how much time is left (counting down). When you look at the cell do you see fine bubbles from the cell producing or not? Is your hook up 240 or 120? What is the salt level? Any other indicators.
_________________
17K Kidney Shaped Pool Concrete (Diamond Bright) Pool, 3/4 hp Sta-rite Duraglas PEA5D-180L, 1.5 piping, Pentair CC100 Filter , Heat Siphon 100K BTU Heat Pump Pool Heater , SWCG CPSC48, SmartPool Nitro SmartKleen NC22 robotic pool cleaner, Lakeland Florida
|
|
|
|
|
|
|
jawroper
|
Post subject: Re: Compupool LCD cycling between Testing and Verify ? Posted: September 18th, 2011, 3:05 pm |
Joined: September 16th, 2011, 1:54 pm
Posts: 2
|
|
It eventually stopped cycling. It took about 13 hours. Now it shows the output level, which I believe is what the LCD should normally show.
The lack of information in the owner's manual on programming the compupool and what the LCD messages mean is frustrating.
|
|
|
|
|
|
|
|
 |
|
 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
RSS Feed 
