|
It is currently May 21st, 2012, 4:11 pm
|
 |
|
 |
|
| Author |
Message |
|
raczkad
|
Post subject: Autopilot Tri-Sensor Issues  Posted: June 24th, 2011, 2:15 pm |
Joined: June 24th, 2011, 1:36 pm
Posts: 2
|
|
We have an old Autopilot LS1000 system that the temperature indicator is red, which is definitely wrong. So we bought a new Tri-Sensor part, but the end plug is not compatible with our circuit board. We would just splice wires & connect, but old cable wires are 3 black, 3 red .. new are white, blue, orange, red, green, black. Does any one have any good documentation on function of each wire going into the LS1000 circuit board top to bottom and the function of each color on the new sensor cable?
|
|
|
|
 |
|
raczkad
|
Post subject: Re: Autopilot Tri-Sensor Issues Posted: June 27th, 2011, 12:26 pm |
Joined: June 24th, 2011, 1:36 pm
Posts: 2
|
|
|
|
|
|
|
winston-rover
|
Post subject: Re: Autopilot Tri-Sensor Issues Posted: October 24th, 2011, 12:24 pm |
Joined: October 24th, 2011, 11:55 am
Posts: 3
|
raczkad wrote: Does any one have any good documentation on function of each wire going into the LS1000 circuit board top to bottom and the function of each color on the new sensor cable? I'm also looking for this documentation, if anyone has it.
|
|
|
|
|
|
|
Poolsean
|
Post subject: Re: Autopilot Tri-Sensor Issues Posted: November 8th, 2011, 7:58 pm |
| Special Contributor |
 |
Joined: April 15th, 2007, 9:48 pm
Posts: 1199
Location: Ft Lauderdale, Florida
|
|
Top to Bottom on the Tri-sensor cord (there is no polarity preference):
Red
White : FLOW SWITCH
Brown
Green: Salinity
Black
Blue: Temperature
_________________
Sean Assam
Commercial Products Sales Manager
Aqua Cal Heat Pumps
AutoPilot Salt Chlorine Generators
www.autopilot.com
www.aquacal.com
sean@teamhorner.com
|
|
|
|
|
|
|
|
 |
|
 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
RSS Feed 
