|
It is currently May 21st, 2012, 3:57 pm
|
 |
|
 |
|
| Author |
Message |
|
bartlettcl
|
Post subject: Autopilot DG-220 pump motor replacement  Posted: January 4th, 2012, 11:42 am |
Joined: January 4th, 2012, 11:24 am
Posts: 1
|
|
I just installed a new Hayward replacement pump motor. When I flipped the breaker back on to power my system the DG-220 came on and my pump came on. Now the pump runs all the time and I can't turn it off with the DG-220. Any suggestions?
|
|
|
|
 |
|
Poolsean
|
Post subject: Re: Autopilot DG-220 pump motor replacement Posted: January 5th, 2012, 7:57 pm |
| Special Contributor |
 |
Joined: April 15th, 2007, 9:48 pm
Posts: 1199
Location: Ft Lauderdale, Florida
|
|
Check and make sure the DIG220 is still programmed to run the pump. Did you change anything in the pump wiring internally?
_________________
Sean Assam
Commercial Products Sales Manager
Aqua Cal Heat Pumps
AutoPilot Salt Chlorine Generators
www.autopilot.com
www.aquacal.com
sean@teamhorner.com
|
|
|
|
|
|
|
thepoolman
|
Post subject: Re: Autopilot DG-220 pump motor replacement Posted: January 24th, 2012, 4:35 pm |
Joined: January 24th, 2012, 12:21 pm
Posts: 96
|
|
Did you remove the wires from the autopilot when changing the motor? If you did, sounds like when you re-wired everything you wired the pump back up to where the power comes into the unit and not where the unit gives power to the pump.
_________________
25K aggregate IG, Intellipro, FNS48, Polaris 360, PG2000 fiber optic light source
|
|
|
|
|
|
|
|
 |
|
 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
RSS Feed 
