|
It is currently May 17th, 2012, 2:04 pm
|
 |
|
 |
|
| Author |
Message |
|
Timbo99
|
Post subject: Aqua Logic controller issue  Posted: December 30th, 2011, 2:24 pm |
Joined: December 30th, 2011, 2:11 pm
Posts: 2
|
|
I have an Aqua Logic PS-8 controller. The pump comes on at the programmed time but no other commands work (such as service mode, lights, etc). Even when the pump is off I cannot mannually get it to turn on by pressing 'Filter' button on the controller. Also. the 'check system' LED is on and the readout says to inspect cell. I cleaned the salt cell and it wont reset the error when holding the + button for 3 seconds. Anyone have any ideas on these problems? Thanks!
|
|
|
|
 |
|
PoolGuyNJ
|
Post subject: Re: Aqua Logic controller issue Posted: December 30th, 2011, 6:32 pm |
| Special Contributor |
 |
Joined: May 20th, 2007, 4:29 pm
Posts: 3046
Location: South Central NJ
|
|
Sounds like a fried control panel. Do you have a remote?
Scott
_________________
Owner of - PoolGuyNJ LLC
Expert Pool and Spa Repairs, Renovations, and Augmentation. Helping people decide what is the right gear for meeting their needs. Expectations Set, Expectations Met, No Surprises.
|
|
|
|
|
|
|
Timbo99
|
Post subject: Re: Aqua Logic controller issue Posted: January 3rd, 2012, 9:51 am |
Joined: December 30th, 2011, 2:11 pm
Posts: 2
|
|
Scott, thanks for the reply. I have a wired remote in the master bedroom. I have no control from that remote either. I would assume its probably the main GLX circuit board that needs repair/replacement. I found a guy on E-bay that repairs the PCB for less than $200 with a 90 day warranty. Any feedback would be appreciated.
Tim
|
|
|
|
|
|
|
|
 |
|
 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
RSS Feed 
