Wow. I return--10 days later. Feels like I have gone off to college and graduated. I have been schooled--Pool Schooled!

I have been managing my water the way I did growing up--when we had a DE filter. Apparently, all the backwashing back in the day took care of the CYA build up, unlike my current cartridge filter. Algae has been my problem all along!

I would be happy if I only had to clean this filter once a month. I think my next "upgrade" will be a SWG, so I can keep chlorine in this pool, and CYA out!

It is amazing how much better my flow is, even this week while the pool was in shock. I don't have to rob suction from my skimmer just to run my cleaner--I can leave both valves open and the cleaner runs around good enough. Operating suction starts at 4 inches. Filter pressure starts clean at 6 psi. Filter pressure rise was only 3 psi all week, and that is before the shock process was completed. Happy happy!

I will still install the new check valve and increase the plumbing to two inches this winter. Hopefully I can get the SWG done before spring. Any idea how much a SWG will increase TDH?

I was quoted for my Goldline about 1 PSI @ 80 GPM so not much.

I am getting ready to re-pipe the pressure side of the pump, including new Jandy check valve. I will also be using a 2" PVC coupler to go over the outside of a Jandy valve. Is there a special glue or procedure to glue up these valves to pvc pipe? I have the standard PVC glue, but I do not have any CPVC glue or experience with that in combination with PVC pipe. Thanks for any help.

Use Oatey all purpose red weld. It is good for both PVC and CPVC pipe.